5/10/15pcs Car Dent Repair Hot Melt Glue Stick 7mm Free Sheet Metal Repair Pulling Special Repair Tools High Adhesive Non-marking

High-adhesion hot melt glue stick. Sheet metal free repair No damage to the original car paint.

Professional strong resistance and high flexibility. Strong melting when the glue is uniform and smooth. Long-lasting firm aging resistance, high strength stretching is not easily broken, high flexibility.

High viscosity is not easy to degumming, breathable place can be stored for a long time is not easy to aging. After curing the tensile force of large flexibility does not lose viscosity, four seasons, put in a cool place to save.

Dented repair methods: high viscosity glue stick and lighter
1. Use a lighter to heat and melt one end of the glue stick 2. Stick the heated end in the sunken position.    
Fixed, light pressure
3. Hold the glue stick gently with your hand until the glue stick is completely melted. 4. Slowly pull the glue stick with your hand until the pit dries and hardens.    
Dry and harden the pits and flatten them. (Remove the glue stick or clean up the residual glue can be used 95 degrees of wine    
(Remove the glue stick or clean up the residual glue can use 95 degree alcohol, drugstore or hardware store sell).

Dented repair method two: high adhesive glue stick and hot melt glue gun
1. put a glue stick into the glue gun and heat it for 15 minutes 2. use the glue gun to hit the glue to the other end of the glue stick    
3. Stick the end of the glue stick with glue on it to the body 4. Wait for about 5 minutes for the glue to harden, then you can use your hand to pull the glue stick until it is concave.    
Pull the glue stick by hand until the depression is flattened. (State under the glue stick to clean up the residual glue can be used 95 degrees alcohol. Drugstores or hardware stores sell)

Size:7mm*160mm

Question 1: The glue is not strong, the glue is debonded, what is the reason?

1. The viscosity of hot melt adhesive is related to the temperature. The ideal temperature is 20°C-28°C.

Note: Do not operate under the sun in summer, and the operating temperature in winter is above 10 ℃ (if the weather is very cold, you can first pour hot water on the wagon in the recess)

2. If the car has been waxed or plated with crystal film or the material of the recess is not iron sheet, the stickiness of the tape will be greatly affected.

3. It may be that the product is dusty during use. Before use, it is best to use alcohol to clean the rubber strip, the dent surface and the gasket.

4. If it is degummed during operation at ideal temperature, this is a normal phenomenon, and it only needs to repeat the operation.

If the depression cannot be repaired after repeated operations, it may be that the puller is not suitable for processing the depression. This is related to the shape, position and size of the depression. Not all depressions can be repaired with one product, which has nothing to do with the glue.

Question 2: How to remove the glue

You can use alcohol above 95 degrees, while tearing it again and spraying alcohol, the residual glue can be buttoned off with your fingernails. Asphalt, gasoline or diesel can also be used.

(Because alcohol is flammable and cannot be transported, please buy it locally. Sorry for the inconvenience caused.)